13
WWW.PARKERMOTION.COM
PH: (724)
-
861
-
8200
HMR Series Positioners
7
Assembly
7.1
Important Information
HMR installation, and all other installations, may only be carried out by trained mechanical technicians or electricians.
The information in these instructions must be strictly observed.
Tightening torques for screws
Thread
Tightening torque
Tolerance
M3
1.2 Nm
± 0.2 Nm
M4
3 Nm
± 0.5 Nm
M5
5.5 Nm
± 0.8 Nm
M6
10 Nm
± 1.5 Nm
M8
20 Nm
± 3 Nm
M10
40 Nm
± 6 Nm
Remarks regarding use and operation:
ATTENTION
Excessive forces or loads
Overload of the HMR would be possible
►
Adhere to catalog data
Mechanical
Additional drill holes or other machining may not be implemented on the HMR!
►
Only attach the payload
at the threaded holes on the carriage
in section 7.3.
►
Adhere to the permissible load limits such as weight, speed and acceleration.
►
Adhere to the permissible load limits such as weight, speed and acceleration.
Combined loads
The maximum permissible load for linear drives subject to simultaneous multiple loads, forces and bending moments
are calculated using the formula below. Maximum permissible loads must not be exceeded.
The sum of all loads must under no circumstance be > 1.
Take note of the additional information in the Parker HMR
catalog
on the
“
Maximum permissible load
”
.
Electrical information
►
The controller, motor, position detection and all other necessary electrical elements must be connected according to technical
rules, within the responsibility of the operator.
►
Do not place magnetic switches in the vicinity of ferritic parts or moving loads.
►
Only use the seating grooves and/or the mounting holes on the aluminum profile for the assembly and mounting of
the profile
version, as described in detail in the HMR catalog.
