ASSEMBLY INSTRUCTIONS
FRONT WHEEL ASSEMBLY
Install front wheel bracket (1) to fron
housing using 5/16” flat washer (2) and
5/16” nyloc nuts (3) and tighten. Install
front wheel (4) into front wheel bracket (1).
Slide nylon washer (7) onto clevis pin (5)
and slide clevis pin (5) all the way through
front wheel bracket (1) and front wheel (4).
Slide second nylon washer (7) onto clevis
pin (5) and secure with hairpin (6).
HANDLE ASSEMBLY
Install handle assembly to blower, place
rubber shim (1) under handle strut (2)
and place 5/16-18 x 2” bolt (4) and 3/8”
washer (3) into holes in handle strut (2)
and through frame (5) and tighten (not
all the way) with 5/16” washer (6) and
5/16-18 nyloc nut (7). Place handle (8)
into handle struts (2) and align holes in
handle (8) and struts (2). Place 5/16-18
x 2” bolt (4) and 3/8” washer (3) into strut
(2) and handle (8), as shown, and
tighten with 3/8” washer (3) and 5/16-18
nyloc nut (7). Tighten bolts on strut /
frame at this time. Pull Pull-Rope handle
(9) towards strut (2) and install rope
guide (10) aroundpull-rope. Place ¼-20
x 2.5” bolt (11) through rope guide (10)
and strut (2) and tighten with 5/16”
washer (6) and ¼-20 nylock nut (12).
6
