CTC Parker Automation
A3-06057-102
P C 9 / P 9 C h a s s i s F a n R e p l a c e m e n t
Introduction
These instructions explain how to replace the fans that cool the configura-
tion bay and the maintenance compartment in the PC9 Industrial PC or the
P9 PowerStation. They include steps for disassembling the unit, removing
an old fan, installing a new fan, and reassembling the unit.
Warning
For safety reasons, the unit should be opened only by qualified
service personnel.
Warning
Be sure to observe electrostatic discharge (ESD) precautions
while working inside the unit.
To complete this procedure, you will need the following items:
•
Replacement Fan for PC9/P9 (FAN-9000)
•
Phillips-head screwdriver
•
5/16” nut driver
Disassembling the Unit
To disassemble the unit, follow these steps:
1. Turn off the unit.
2. Disconnect the unit from the power source.
3. Disconnect all cables attached to the unit.
4. Remove the two screws securing the backshell to the faceplate as-
sembly, as shown in Figure 1 on page 2.
