PC9/P9 Chassis Fan Replacement
CTC Parker Automation
3
7. If you have a P9, detach the three cables connecting the faceplate
assembly and backshell, as shown in Figure 3.
Figure 3: Disconnecting P9 Cables
a.
Detach the monitor (ribbon) cable from its connection at
the center of the monitor frame (push back the locking
clamps from either side of the connector).
b. Detach the touchscreen cable from its extender in the
maintenance compartment.
c.
Detach the backlight cable from its connection on the
monitor card (press down on the small tab on the lower
half of the connector, and pull the cable out).
8. Remove the safety bracket below the upper hinge of the backshell
by removing the screw that holds the bracket in place. This bracket
is shown in Figure 4 on page 4.
Warning
Make sure that both the faceplate assembly and backshell are
supported when you remove the safety bracket and when you
open the backshell.
Monitor card
Detach the
backlight cable
here
Detach the
Detach the
monitor cable
here
MAINTENANCE
COMPARTMENT
touchscreen
cable here
