Chapter 2: Installing the Monitor
Mounting the Monitor in an Enclosure
PHM/PM User Guide
2-6
Mounting the Monitor in an Enclosure
Read this section if you intend to mount the monitor in an enclosure. If you
plan to mount the monitor on an adjustable arm, see the documentation
that accompanies the arm for installation instructions.
Creating a Cutout
When mounting the monitor in an enclosure, you first need to create a
cutout for the unit and clean the area of any dirt or debris that might come
in contact with the monitor.
1
Measure the cutout dimensions as shown in the table below.
2
Cut out the marked area. The cutout dimensions depend upon the
size of your monitor. To maintain the flatness of the mounting
surface, it is recommended that you punch out the mounting hole, as
you should maintain proper surface flatness and edge quality.
Refer to the CD that comes with the monitor for the depth and port
dimensions of your monitor. Use these dimensions to customize the
mounting of your unit.
Important If using an external AC adapter, remember to take the
adapter’s dimensions into account when planning the
depth of the monitor enclosure.
3
Debur the edges of the cutout area, removing dirt and debris that
might come in contact with the unit.
Mounting an External AC Adapter
The monitor uses DC power. You can however, operate the monitor using
AC power by ordering an optional external AC adapter.
The External AC Power Supply Adapter (P1X-PWRAC) is available from
Parker-CTC, along with an installation kit (BKT-1000) that allows you to
mount the adapter either on the back of the monitor or near it.
Caution
Do not apply AC power to the unit without the AC adapter or
damage may occur.
Monitor Size
Cutout Height
Cutout Width
15” (stainless steel bezel)
12.40” (315mm)
15.90” (404mm)
15” (standard bezel)
12.40” (315mm)
15.90” (404mm)
17” (standard bezel)
14.26” (362mm)
17.06” (433mm)
