Publication PSS-UM001A-EN-P – June 2005
1.
Expand the list of
Communication
Adapters.
2.
Select the
PSSCDM12A
IsysNet
Scanner.
3.
The scanner
appears
on
the
network.
IMPORTANT
The scanner must always exist
on the Subnet at Node 00.
Chapter
4
Configure the DeviceNet Scanner Subnet
This chapter describes how to custom configure your scanner
for use with Isysnet I/O modules.
See the Following Sections:
Page:
Configuration Overview
4-1
Add the Scanner to Your Network
4-1
Add I/O Modules to Your Network
4-1
Set the Scanner's Parameters
4-2
Go On Line
4-6
Chapter Summary and What’s Next
4-6
Your adapter works on two networks simultaneously and must
be configured for each separately. This chapter explains
configuration of the scanner for use with Isysnet I/O modules.
For information on how to configure the adapter for use on the
DeviceNet Network, see Chapter 5, Adding the DeviceNet
Adapters to the DeviceNet Scanner's Scanlist.
Configuration Overview
You must use the RSNetWorx for DeviceNet software to configure
your scanner. You can configure the scanner while it is:
• On Line
• Off Line
This chapter shows configuration in the offline mode. Configuration
screens appear the same in both modes. Note that some screen
options are unavailable in offline mode. The only difference is that if
you make changes off line, you must take the scanner on line
before the configuration changes take effect.
IMPORTANT
Throughout most of this manual, we refer to the Isysnet I/O
DeviceNet adapter as the adapter. The adapter also
communicates with Subnet modules as a scanner. In this
chapter only, the adapter is referred to as a scanner.
You must follow these steps during configuration:
1.
Add the scanner to your network
2.
Add I/O modules to your network
3.
Set the scanner’s parameters
4.
Go on line
Add the Scanner To Your Network
Follow these steps:
1.
Start RSNetWorx for DeviceNet.
2.
Add the scanner as shown below.
Add I/O Modules To Your Network
After you add the scanner, you must add the modules connected to
the scanner on the Subnet. In the offline mode, I/O modules must
be added individually. Follow these steps:
1.
Add modules as shown below.
1.
Expand Vendor
➞
Parker Hannifin Corp.
to display the list
of I/O modules.
2.
Double Click the
I/O module you
want to add to
the
network.
TIP:
You can also
click and drag the
module name onto
the network.
We used the PSSN8M12A,
PSST8M12A, and PSSNACM12A
I/O modules in this example. Your
network screen should reflect the
I/O modules on your network.