User Guide
15
Mounting the PVSG-IQAN to a Vehicle
3.2. Designing and Connecting the Vehicle
Harness
The vehicle manufacturer or integrator is responsible for designing a
vehicle harness that mates with the PVSG-IQAN connector(s).
The vehicle harness design depends on the following:
How the users's inputs, outputs, communication, and power pins are
configured.
Other components on the vehicle and their physical locations.
The routing of the harness.
Details on recommended wire diameters for use with the product
connector are covered in the connector manufacturer’s datasheet. Wire
diameters used should be sufficient for the expected module current.
To use the remote diagnostic features of the PVSG-IQAN gateway, the
diagnostic bus of the gateway must be properly connected to the
diagnostic bus of the IQAN control system.
Once the vehicle harness is designed, it can be connected to the PVSG-
IQAN simply by clicking the mating connectors into the connector ports on
the PVSG-IQAN.
Damage to Equipment!
The technician installing the connector
should take special care that the connector is inserted in the
correct orientation as power applied to unprotected pins can
cause permanent damage to the gateway.
Summary of Contents for PSVG-IQAN-C2E1M1W1U1
Page 42: ...34 PSVG IQAN C2E1M1W1U1 Markings Approvals 9 3 EU Declaration of conformity...
Page 43: ...User Guide 35 Markings Approvals...
Page 47: ......
Page 48: ...HY33 5027 IB US...