6
Siemens APOGEE P1 Communications Interface
Initial Check for Connection
With the correct connections to the active
APOGEE Controller, the MODULE LED
will be ON continuously and the
NETWORK LED will indicate the IDLE state
with a flash.
Understanding the LED Indications
Figure 5 Technology Option LEDs
HINT
:
The general rule for LED indications is
“ON IS GOOD, OFF IS BAD”
Health and Run LEDs
HVAC10 Size 1 (6053) Technology Box
These LEDs reproduce the indications of the LEDs on the HVAC10 drive that are hidden when
the Technology Box is fitted.
HVAC10 Size 2 & 3 (6055) Technology Box
The board does not have its own Health or Run LEDs. The LEDs are either on the Operator
Station or blank cover.
Module LED
This indicates the set-up state of the Technology Box. The states indicated are those produced
by the FAULT parameter of the TEC OPTION function block.
Module LED Indication
FAULT Parameter Indication Description
OFF
SELF TEST
Initialising
SHORT FLASH
HARDWARE Hardware
fault
FLASH
TYPE MISMATCH
Wrong type or disabled
LONG FLASH
PARAMETER
Set-up fault, parameter
values out-of-range
ON
NONE
Valid set-up, ready for
external communications
ON
MODULE LED
FLASH
NETWORK LED
HEALTH
NETWORK
MODULE
RUN
6053 Technology Box
HVAC10 Size 1
HVAC10 Size 2 & 3
TB1
SW1
6055 Technology Box
NETWORK
MODULE
PLG1
Summary of Contents for Siemens APOGEE P1
Page 6: ......
