8
Siemens APOGEE P1 Communications Interface
Initial Set-up for APOGEE P1
Configuring the Drive
Using the Operator Station (MMI) or other suitable PC programming tool, the TEC OPTION function block requires
configuring before the APOGEE P1 option can be used.
The parameter names/functions in the TEC OPTION function block are inter-dependant and will
change with different parameter values and the various Technology Options that can be fitted.
The top function block diagram shows the DSE Lite parameter names, which are also displayed
on the MMI if no Technology Option is fitted or an incorrect TYPE is selected for the fitted
Technology Option.
DSE Lite is Parker SSD Drives’ Windows-based block programming software.
When the TYPE parameter is set to display RS485, the function block parameters take on new
identities, as shown in the lower Function Block diagram.
Selecting Siemens APOGEE P1
(Select Advanced view level on the Operator Station and view the TEC OPTION function
block).
•
Select RS485 in the TYPE parameter
•
Select P1 FLN in the PROTOCOL parameter
•
Select the node ADDRESS (0 to 31)
•
Select the BAUD RATE (default is 4800)
•
Check the FAULT parameter for error messages and rectify if necessary
When setting values for parameters from DSE Lite (or other suitable PC programming tool) you
are able to select any value in the parameter’s range, i.e. -32768 to 32767. If the value is
incorrect, i.e. it doesn’t correspond to a value that can be set using the MMI, then the FAULT
output parameter will
be set to
PARAMETER.
MMI Parameter Descriptions for APOGEE P1
TYPE
Range: Enumerated - see below
Selects the type of Technology Option. The TYPE parameter is automatically set when defaults
are loaded if a Technology Option is present.
Enumerated Value : Type
0 : NONE
1 : RS485
2 : PROFIBUS DP
3 : LINK
4 : DEVICENET
5 : CANOPEN
6 : LONWORKS
7 : CONTROLNET
8 : MODBUS PLUS
9 : ETHERNET
PROTOCOL
Range: Enumerated - see below
Selects the protocol to be used.
Enumerated Value : Protocol
0 : EI ASCII
1 : EI BINARY
2 : MODBUS RTU
3 : P1 FLN
4 : METASYS N2
MMI Menu Map
Non-specific MMI view
1
SETUP
2
COMMUNICATIONS
3
TEC OPTION
TYPE
INPUT
1
INPUT
2
INPUT
3
INPUT
4
INPUT
5
FAULT
VERSION
OUTPUT
1
OUTPUT
2
MMI Menu Map
MMI view
1
SETUP
2
COMMUNICATIONS
3
TEC OPTION
TYPE
PROTOCOL
ADDRESS
BAUD
RATE
UNUSED
1
UNUSED
2
FAULT
VERSION
NETWORK
STATE
NIGHT
Summary of Contents for Siemens APOGEE P1
Page 6: ......
