117 - PVD 3622_GB_TM_January 2014.Docx
10
–
Keep the nut tightened until the internal ring cools and shrinks.
11
–
Unscrew and remove the KMT nut and the shutting collar
.
12
– Mount a
new lip seal
(
alcohol mounting
) :
The following table gives the recommended lip seal references (Techne) :
Thrust
Bearing Ref
29420
29422
29424
29426
29430
29434
29440
Techne seal
ref.
A180*215*16
NBR
A210*240*15
NBR
A230*255*15
NBR
A250*280*15
NBR
A280*310*15
NBR
A320*350*15
NBR
A370*410*15
NBR
Parker seal
ref.
5320P0058
5320P0052
5320P0059
5320P0054
5320P0064
5320P0063
5320P0065
13
– Re-insert
the shutting collar
14
– Re-insert and screw down
the KMT nut.
Tightening torque :
300 to 400 Nm
15
–
Screw down the locking screws of the KMT nut.
Tightening torque
: 35Nm
16
–
Remove the bridges
on the terminal box and
connect motor phases to the
terminal box.
Put back the terminal box cover
17
–
Connect control cable to the encoder connector
18
–
Before applying power:
* Read the safety section at the beginning of the manual
* Check for damage to equipment
* Check all external wiring circuits of the system
– power, control, motor and earth
connections.
* Ensure that nobody is working on another part of the system who will be affected by
powering up
* Ensure that other equipment will not be adversely affected by powering up.
Summary of Contents for TM Series
