HY13-1527-M1/US
Torqmotor™ Service Procedure
TF, TG, TH and TL Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 US
33
NOTE
Apply clean grease to a
new
seal ring (4)
and assemble it in the seal ring groove in
the rotor set contact side of manifold (7).
SEE FIGURE 46.
NOTE: The manifold (7) is made up
of several plates bonded together
permanently to form an integral
component. The manifold surface that
must contact the rotor set has it’s series
of irregular shaped cavities on the largest
circumference or circle around the inside
diameter. The polished impression left on
the manifold by the rotor set is another
indication of which surface must contact
the rotor set.
Install manifold
and seal ring
14. Assemble the manifold (7) over the drive
link (10) and onto the rotor set. Be sure the
correct manifold surface is against the rotor
set. SEE FIGURE 47.
Apply grease to a
new
seal ring (4) and
insert it in the seal ring groove exposed on
the manifold. SEE FIGURE 48.
Install
commutator ring
15. Assemble the commutator ring (6) onto the
manifold. SEE FIGURE 49.
Figure 46
Figure 47
Figure 48
Figure 49
Torqmotor™ Assembly
