6. COMMAND REFERENCE
93
K
Kill
Syntax
Units
Range of ‘n’
Default
See also
aK
-
-
-
OFF, SETUPFB
Description
The
KILL
command will perform the following functions:
-
Abort a SETUPFB command.
-
Execute an OFF command
-
Set the fault output
This command is used as an immediate stop and does not attempt to control
deceleration.
Properties
Immediate, not saved by SV
Note
Aborting SETUPFB will prevent an energise state from happening and will
flag the motor as being undefined
Motion may only be commanded once the energise input has been cycled
following a
KILL
command.
Care must be taken that the demand is removed before re-energising as the
drive will respond immediately to the demand.
A drive enable error will be indicated which, together with the fault output,
will be reset on a successful energise state.
Summary of Contents for ViX250AE
Page 2: ......
Page 57: ...50 VIX AE SERVO DRIVE USER GUIDE...
Page 123: ...116 VIX AE SERVO DRIVE USER GUIDE...
Page 135: ......