LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom or
shower room. It is essential that the appliance is positioned as stated below. The appliance must be a
minimum of 20mm from the rear wall (note that this dimension is provided by the inlet elbow). Shelves, wall
cabinets and cooker hoods must not be fitted closer that 500mm to the top of the grill canopy or within 100mm
of the sides of the grill. Curtains must not be fitted immediately behind the appliance or within 200mm of the
sides of the grill. If fitted next to or between two base units a minimum space of 1mm must be left between
the units and the sides of the appliance. The hotplate must be set to a minimum of 7mm above the adjacent
units (note that the levelling feet fitted to the appliance will achieve a nominal height to hotplate level of
907mm -5+13mm). Base units not meeting the above conditions must be a minimum of 100mm away from the
hotplate. L.P.G. cookers MUST NOT be installed below ground level, i.e. in a basement.
INSTALLATION
1.
PARTS REQUIRED
The loose hotplate parts are packed in the polystyrene fitment on
the top of the hotplate. The grill pan, grill pan handle, fixing screws
and splashplate fixing screws can be found in the furniture pack
which is located in the bottom compartment. The grill pan requires
assembly before use (see Fig. 1).
2.
GRILL ASSEMBLY
The two splashplate screws should be screwed into the back of
the appliance about halfway in (see Fig. 1a). Engage the keyhole
slots in the splashback behind the two screws taking care not to
trap the H.T. wire (see Fig. 1b).
Tighten 6 of splashplate screws (see Fig.1c).
Connect the grill supply union at the back of the appliance and pull
the grill H.T. lead through the opening in the splashplate and
connect on to the spark generator.
A S T O R I A 3
33
Fig.1
Grill Pan Handle Assembly:
Assemble grill pan (see Fig.1)
and secure two screws provided.
Fig.1c
Fig.1b
Fig.1a
