MEANINGS OF SYMBOLS
NOTE
: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning
before use.
It is important that you read, fully
understand and observe the following
safety precautions and warnings.
Careless or improper use of the unit
may cause serious or fatal injury.
Read, understand and follow all
warnings and instructions in this
manual and on the unit.
Always wear eye, head and ear
protectors when using this unit.
Keep all children, bystanders and
helpers 15 m away from the unit.
If anyone approaches you, stop
the engine and cutting attachment
immediately.
Be careful of thrown objects.
min
-1
Shows maximum shaft speed. Do
not use the cutting attachment
whose max rpm is below the shaft
rpm.
G l o v e s s h o u l d b e w o r n
when necessary,e.g., when
assembling cutting equipment.
Use anti-slip and sturdy footwear.
Blade thrust may occur when
the spinning blade contacts a
solid object in the critical area. A
dangerous reaction may occur
causing the entire unit and
operator to be thrust violently.
This reaction is called blade
thrust. As a result, the operator
may lose control of the unit
which may cause serious or
fatal injury. Blade thrust is more
likely to occur in areas where it
is difficult to see the material to
be cut.
Indicate handle location. Do not
attach handle above this point.
6
Pull out flexible shaft from cover and
grease every 15-20 hours of use.
Insufficient lubrication will cause flexible
shaft damage.
C A U T I O N
CAUTION
Pull out flexible shaft from cover
and grease every 15-20 hours
of use.Insuffi cient lubrication
will cause flexible shaft damage.
Summary of Contents for Professional Series
Page 3: ...1...
Page 4: ...V N M N N N O N P N Q N R N S N S P N O N N N R N Q N T N S N 2...
Page 5: ...3...
Page 6: ...4...
