OEM PS9** SERIES FITTING GUIDE
To ensure a strong adhesion of the support brackets to the bumper clean all internal surfaces around
the holes with the 3M Automotive adhesion promoter 06396. Failure to do so may prevent long term
bond of sensor bracket to bumper. Remove surface dirt and water before using 3M Automotive adhesion
promoter 06396
KEEP THE 3M AUTOMOTIVE ADHESION PROMOTER 06396 OFF ANY PAINTED SURFACES.
Remove the bumper from the vehicle and make the holes using a PSDRILL tool. Clean the inner surface
of the bumper using 3M Automotive adhesion promoter 06396.
LEAVE TO DRY BEFORE STICKING ON SENSORS.
Clean the face of the bracket with 3M Automotive adhesion promoter 06396
before inserting the sensor head.
DO NOT USE THE 3M AUTOMOTIVE ADHESION PROMOTER 06396 ON THE SENSOR
MAIN BODY IT MAY DAMAGE THE SURFACE OF THE SENSOR.
Insert the sensor head into the mount by rotating into
position. Make sure you do not trap the rubber seal.
Stick the 3M pad onto the dry sensor bracket and
then remove the release paper keeping fingers off
the adhesive surface.
Install the sensors in the hole of the bumper from the inside paying
attention to the position and alignment ofthe sensor head. Once this
has been completed, refit the bumper to the vehicle.
Page 4
Summary of Contents for PS440
Page 4: ...WIRING Page 2...