13
GB
CAUTION!
- Battery pack
9
must be removed
from the tool prior to changing the blade
17
.
Do not use any blunt, bent or damaged blade
Always install a suitable saw blade for the job.
1. Turn chuck ring
3
in anti-clockwise direction
2. Insert saw blade
17
into saw blade retainer
2
as per direction
a
.
3. Release chuck ring
3
and let it turns back to
original position
4. Pull the saw blade
17
in direction
b
to check it
is installed properly
Removing the saw blade:
1. Turn chuck ring
3
in anti-clockwise direction
2. Pull the blade
17
from saw blade retainer
2
as per direction
b
.
3. Release chuck ring
3
, it will turn back to
original position
Note:
For certain work, the saw blade can also
be inserted after turning through 180°.
Operation
When working with the device, always wear
suitable clothing and appropriate protective
equipment.
Prior to each use it must be ensured that the
device is working correctly. Personal protective
equipment and a fully functional device reduce
the risk of injuries and accidents.
After the device has been switched off, the
blade continues moving for some time. Do not
touch the moving blade and do not attempt to
brake it. Danger of injury!
Switching on and off
Ensure your stance is stable and hold the tool’s
front handle
5
and rear handle
8
firmly with
both hands. Before switching on the device,
ensure it is not in contact with the work piece.
Switching on:
1. Ensure that battery pack
9
is inserted
properly (see “Attaching / Disconnecting the
battery pack to / from the product”).
2. Press the switch lock
6
and On / Off switch
7
(see Fig. H).
3. Then release switch lock
6
(see Fig. G). The
switch lock
6
moves back into its original
position.
4. By using On / Off switch
7
, you can
progressively control stroke rate.
Gentle pressure : low stroke rate
Greater pressure : higher stroke rate
On/Off switch
7
cannot be locked
Switching off:
Just release On / Off switch
7
.
Note:
LED work light
4
will keep on for
about 10s right after tool is switched off
(On / Off switch
7
is released).
Adjusting the base plate
To adapt to the work piece, the base plate
1
can
be adjusted and swivelled to 4 positions.
Press the adjusting button
13
(see Fig. I).
The base plate
1
can now be adjusted to the
desired position.
After base plate
1
is placed in desired
position, press down base plate adjustment
button
13
back to original position (see Fig. J).
Practical tips
Wear gloves when handling the
saw blade. In this way, you avoid
injury from cuts.
Caution:
Risk of injury and damage to property!
- Do not use any blunt or bent blades or blades
which are damaged in any other way.
- Before sawing the work piece, check for hidden
foreign objects such as nails, screws. These
must be removed.
- Always insert a suitable saw blade.
- Secure the work piece with the aid of
clamping devices on the workbench.
