PSBSAP 20-Li A1
■
8
│
GB
│
IE
│
NI
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable
for indoor use only.
WARNING!
■
To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
♦
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦
Connect the battery pack
!
to the high-speed
charger
0
(see fig. A).
♦
Insert the power plug into the socket. The red
charge control LED
%
lights up red.
♦
The green charge control LED
+
indicates
that the charging process is complete and the
battery pack
!
is ready for use.
ATTENTION!
♦
If the red charge control LED
%
flashes,
this means that the battery pack
!
has
overheated and cannot be charged.
♦
If the red and green charge control LEDs
%
/
o both flash, this means that the battery
pack
!
is defective.
♦
Push the battery pack
!
back into the tool.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
IB_329697_PSBSAP20-LiA1_LB6.indb 8
26.08.20 17:08
Summary of Contents for 329697 2001
Page 3: ...A...
Page 4: ...B...
Page 21: ...PSBSAP 20 Li A1 16 GB IE NI...
Page 37: ...PSBSAP 20 Li A1 32 DE AT CH...
