Parkside Performance 329697 2001, Instructions Manual

PSBSAP 20-Li A1

GB

│

IE

│

NI

 │

9

■

Inserting/removing the battery pack

Inserting the battery pack

♦

Set the rotation direction switch 

 to the middle 

position (lock). Push the battery pack 

!

 into 

the handle until it clicks into place.

Removing the battery pack

♦

Press the release button 

.

 and remove the 

battery pack 

!

.

Checking the battery charge level

♦

Press the battery charge level button 

1

 to 

check the status of the battery (see the main 
diagram). The status/remaining charge will be 
shown on the battery display LED 

6

 as follows: 

RED/ORANGE/GREEN = maximum charge 
RED/ORANGE = medium charge 
RED = low charge – charge the battery

Additional handle

NOTE

►

For safety reasons, you should never use 
this tool without the additional handle 

attached.

♦

Loosen the strap on the additional handle 

by turning it clockwise.

♦

Slide the mounting ring for the additional  
handle 

 over the chuck 

3

.

♦

Turn the additional handle 

 to the required 

position.

♦

Afterwards, twist the additional handle 

anticlockwise again to tighten it.

Depth stop

♦

Push the locking button for the depth stop 

and keep it pushed in.

♦

Fit the depth stop 

 into the additional  

handle 

.

♦

Make sure that the teeth on the depth stop 

point upwards and downwards.

♦

Pull the depth stop 

 out until the distance  

between the tip of the drill and the tip of the 
depth stop corresponds with the required  
drilling depth.

♦

Release the locking button for the depth stop 

to lock the depth stop 

 in place.

Changing tools

Your cordless impact drill driver has a fully auto-
matic spindle lock 

.

When the motor is stopped, the power train is 
locked so that the chuck 

3

 can be opened by 

turning 

. After you have attached the desired 

tool and tightened it by turning the chuck 

, you 

can continue working. The spindle lock is released 
automatically when the motor is started (by pressing 
the ON/OFF switch 

).

Torque selection/selecting the 
 operating  mode

You can set the torque using the torque selection 
ring 

-

 or by choosing between the drill setting   

and the hammer drill setting    .

♦

Select a low level for small screws or soft  
materials.

♦

Select a high level for large screws, hard  
materials or removing screws.

♦

Select the drill setting for drilling work by adjusting 
the torque selection ring to the position  .

♦

Select the hammer drill setting for hammer drilling 
work by adjusting the torque selection ring to 
the position    .

IB_329697_PSBSAP20-LiA1_LB6.indb   9

26.08.20   17:08