PASSP 20-Li A3
■
8
│
GB
│
IE
Inserting/removing the battery pack
Attaching the battery pack
♦
Push the rotation direction switch into the
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the belt clip
♦
Loosen the fixing screw
3a
using a standard
Phillips screwdriver (not supplied).
♦
Hold the corresponding hole of the belt clip
over that of the screw thread.
♦
Tighten the fixing screw
3a
.
Switching on/off
Turn on
♦
Press and hold the ON/OFF switch to
start up the tool.
The LED work light lights up when the
ON/OFF switch is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦
Release the ON/OFF switch to switch off
the appliance.
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque selector to select the
required torque in stages. The selected torque is
shown on the torque display .
♦
Press the ON/OFF switch lightly for a low
speed and a low tightening torque. Increasing
the pressure increases the speed and the tight-
ening torque.
■
The tightening torque depends on the selected
speed/torque selection and impact duration.
NOTE
►
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
►
The integrated motor brake ensures that the
tool stops quickly.
ATTENTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
♦
Change the direction of rotation by pressing the
rotation direction switch towards the left or
right.
Fitting a socket
♦
Push one of the supplied sockets or the
adapter onto the tool holder .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the appliance off and
remove the battery before carrying
out any work on the appliance.
The tool is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the tool.
Summary of Contents for PASSP 20-Li A3
Page 3: ...A 3a...
Page 24: ...PASSP 20 Li A3 14 GB IE...
Page 138: ...PASSP 20 Li A3 128 DK...
Page 180: ...PASSP 20 Li A3 170 SI...
