PSBSAP 20-Li A1
GB
│
IE
│
25
■
2-speed gearbox
CAUTION!
►
Operate the speed selector switch
only
when the tool is at a standstill. Otherwise,
the tool could be damaged.
In first gear
(speed selector switch
in position 1),
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
work.
In second gear
(speed selector switch
in position 2),
you can reach a speed of approx. 2000 rpm for
carrying out drilling work.
Operation
Switching on/off
Turn on
♦
Press and hold the ON/OFF switch
to start
the tool. The LED work light
lights up when
the ON/OFF switch
is pressed lightly or
fully. This provides illumination of the work
area in poor lighting conditions.
Switching off
♦
Release the ON/OFF switch
to switch off
the tool.
Setting the rotational speed
Pressing the ON/OFF switch
lightly yields a low
speed. Increasing the pressure increases the speed.
NOTE
►
The integrated motor brake ensures that the
tool stops quickly.
Changing the direction of rotation
♦
Change the direction of rotation by pushing the
rotation direction switch
to the right or left.
Tips and tricks
Tip! How to do things correctly.
♦
Before operation, check whether the screw
or drill bit is correctly fitted, i.e. centred in the
chuck.
♦
Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check first whether the bit fits tightly in
the screw head without any play.
Torque
♦
Smaller screws/bits can be damaged if you
set too high a torque or too high a speed.
Hard screw joints (in metal)
♦
Particularly high torques occur, e.g. in metal
screw joints when using drive sockets. Select
a low rotational speed.
Soft screw joints (e.g. in soft wood)
♦
Here, too, use a low speed to avoid damaging
the wood surface when it comes into contact
with the metal screw head. Use a countersink.
Small screws can be screwed directly into soft
wood without predrilling.
When drilling in wood, metal and other
materials, observe the following:
♦
Use a high speed for drill bits with a small
diameter and a low speed for drill bits with
a large diameter.
♦
Select a low speed for hard materials and
a high speed for soft materials.
♦
Mark the spot where you want to drill using
a centre punch or nail. Select a low rotational
speed when starting.
♦
Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
IB_329699_PSBSAP20-LiA1_LB8.indb 25
26.08.20 13:41
Summary of Contents for PSBSAP 20-Li A1
