7
PDEXS 150 B2
GB
Before use
NOTE
►
The sander may only be operated on
cleaned, oil-atomised compressed air and
may not exceed the maximum operating
pressure of 6.3 bar at the appliance. The
compressor must be fitted with a pressure
reducer to regulate the working pressure.
►
Wind the Teflon tape supplied around all
threaded connectors.
Fitting the connector nipple
♦
Remove the plastic protective cap from the
appliance's air inlet.
♦
Wrap the threads on the connector nipple
with the Teflon tape supplied.
♦
Screw the connector nipple into the air inlet.
Fitting the sanding disc
The compressed air-powered random orbital sander
is equipped with a protective cuff .
■
Rotation direction indicator of the
sanding disc
♦
To fit or replace the sanding disc invert the
protective cuff (see Fig. 1).
Fig. 1
WARNING!
►
Never operate the compressed air-powered
random orbital sander without the protective
cuff .
►
Never operate the compressed air-powered
random orbital sander with an inverted
protective cuff .
►
A damaged protective cuff should be
replaced immediately.
♦
Turn the spindle lock with the knurled bulge
towards the flat side of the eccentric spindle
(see Fig. 2).
Fig. 2
♦
Remove the protective cap from the threaded
rod of the sanding disc and screw it clock-
wise into the eccentric spindle as far as the
stop.
♦
Undo the spindle lock so that the eccentric
spindle can turn freely on its own axis.
CAUTION!
►
Never operate the compressed air-powered
random orbital sander with a locked drive
spindle. This is dangerous and can result in
serious injuries.
♦
Evert the protective cuff again (see Fig. 3).
♦
Fig. 3
Selecting a sandpaper disc
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper.
■
Please note that you can use sandpapers with
various grain sizes for working the different
materials.
Summary of Contents for 275679
Page 3: ......
