Parkside 283718, Translation Of The Original Instructions

PHP 500 D2

GB

│

IE

│

 9

■

and are aware of the potential 
risks. Children must not play with 
the appliance. Cleaning and user 
maintenance tasks may not be car-
ried out by children unless they are 
supervised.

■

To avoid potential risks, damaged mains cables 
should be replaced by the manufacturer, their 
customer service department or a similarly 
qualified person.

Additional safety instructions for 
glue guns

■

Children should be supervised to ensure that 
they do not play with the appliance.

■

CAUTION! This appliance must be placed on 
its stand when not in use.

■

Always protect the appliance from rain and 
moisture. Water entering a power tool will 
increase the risk of electric shock.

■

Do not misuse the power cord, e.g. to carry 
or hang up the appliance, or to pull the plug 
from the socket. Keep cord away from heat, 
oil, sharp edges or moving parts. If the power 
cord is damaged or severed during work, do 
not touch the cord but rather pull out the power 
plug. Damaged or entangled cords increase the 
risk of electric shock.

■

Only for indoor use.

■

If you take a break of longer than 30 minutes, 
pull out the power plug.

■

Allow the appliance to cool completely after 
use and before storage.

■

Do not work on any material containing asbestos.

■

Avoid the risk of injury or fire as well as health 
risks: RISK OF BURNS! The adhesive and the 
nozzle reach a temperature of around 200°C. 
Do not touch the nozzle or the glue. Do not 
allow hot glue to come into contact with people 
or animals. In case of contact with skin, rinse 
the affected part in cold running water for a few 
minutes. Do not attempt to remove the adhesive 
from the skin.

■

Always route the power cable towards the rear, 
away from the appliance.

Operation

Before use

Preparing the surfaces to be glued:

■

Do not use flammable solvents to clean the 
surfaces to be glued.

■

The ambient temperature and the materials to 
be bonded may not be colder than 5°C and 
not warmer than 50°C.

■

The area to be glued must be clean, dry and 
free of grease.

♦

Smooth surfaces should be roughened before 
gluing.

♦

Quick-cooling materials such as steel should be 
warmed a little to facilitate adhesion.

♦

Select the desired nozzle  .

Using the appliance

Mains operation:

♦

Connect the power cable   to the mains 
connection of the glue gun   (see fig. B). Insert 
the power plug into the socket.

♦

Fold down the plastic stand  . Put down the 
appliance.

♦

Push a glue stick into the feeder shaft  .

♦

Allow the appliance to heat up for about  
5 minutes. The appliance is now ready for use.

Battery operation:

♦

Connect the power cable   to the mains 
connection of the charger  . Insert the power 
plug into the socket.

♦

Place the glue gun into the charger  .

♦

Push a glue stick into the feeder shaft  .

♦

Allow the appliance to heat up for about  
5 minutes. The appliance is now ready for use.

♦

Repeat the heating phase if the glue is still too 
thick or viscous.