PWSA 20-Li B2
GB
│
IE
│
21
■
Package contents
1 cordless angle grinder PWSA 20-Li B2
1 additional handle
1 blade guard (pre-assembled)
1 two-hole mounting spanner
1 cutting disc (pre-assembled)
1 set of operating instructions
Technical details
Cordless angle grinder: PWSA 20-Li B2
Rated voltage:
20 V
(DC)
Rated idle speed:
n 2500–10000 rpm
Disc width:
Ø 115 mm
Thread size:
M14
Use the following battery to operate the
cordless tool: PAP 20 A3*
Type:
LITHIUM
ION
Rated voltage:
20 V
(DC)
Capacity:
4
Ah
Cells: 10
To charge the battery pack rapidly use the
following high-speed battery charger:
PLG 20 A2*
INPUT:
Rated voltage:
230–240 V ~, 50 Hz
(AC)
Rated power
consumption: 85
W
Fuse (internal):
3.15 A
T3.15A
OUTPUT:
Rated voltage:
21.5 V
(DC)
Rated current:
3.5 A
Charging time:
approx. 80 min
Protection class:
II / (double insulation)
*BATTERY AND CHARGER ARE NOT INCLUDE
Noise and vibration data:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Noise emission value:
Sound pressure level: L
PA
= 84 dB(A)
Uncertainty: K
=
3
dB
Sound power level:
L
WA
= 95 dB(A)
Uncertainty: K
=
3
dB
Wear hearing protection!
Total vibration value:
Surface grinding main
handle: a
h, AG
= 1.83 m/s
2
Uncertainty:
K = 1.5 m/s
2
Surface grinding additional
handle:
a
h, AG
= 1.224 m/s
2
Uncertainty:
K = 1.5 m/s
2
NOTE
►
The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also be
used to make an initial exposure estimate.
WARNING!
►
The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
Summary of Contents for 290849
Page 3: ...B A...
Page 4: ...D C...
Page 61: ...PWSA 20 Li B2 56 FR BE...
Page 117: ...PWSA 20 Li B2 112 ES...
