PWBS 180 A1
GB
│
IE
│
NI
│
CY
│
11
■
♦
To prolong the service life of the accessory tool,
ensure that you apply even pressure .
♦
Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool .
♦
Lift the appliance off the working surface .
♦
For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose .
Sanding close to the edge
If you are sanding close to the edge, you can
remove a hood segment of the protective and
suction hood . This means that the accessory
tool you are using is closer to floor, wall and ceil-
ing edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined .
Expect dust to develop during this work, as the pro-
tective and suction hood is no longer closed off .
♦
Pull the hood segment forwards out of the
protective and suction hood .
♦
Work the surfaces close to the edge .
♦
Push the hood segment back into the suction
hood until it locks into place .
Operation
■
Tool direction of rotation!
Switching on
♦
To
switch on
the appliance, slide the On/Off
switch forwards .
To lock the On/Off switch , press the On/Off
switch down at the front until it clicks
into place .
Switching off
♦
To switch off the power tool, let go of the On/
Off switch . If it is locked, press the rear end
of the On/Off switch and then release it .
Setting the rotational speed
Before starting work, set the speed to suit the
application . Use a low speed for coarse sanding;
increase the speed for fine sanding .
■
Adjust the speed by pressing the buttons .
♦
Press the
+
button to increase the speed .
♦
Press the
–
button to decrease the speed .
NOTE
►
The accessory tool rotates after switching off .
Wait until the accessory tool has come to a
standstill before putting down the appliance .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work on the appliance.
■
The appliance is maintenance-free .
■
Do not use any sharp objects for cleaning
the appliance. Do not allow any liquids to get
into the appliance.
The appliance could be
damaged .
■
Clean the appliance regularly, preferably imme-
diately after completion of the work .
■
Clean the housing with a dry cloth – do not use pet-
rol, solvents or cleaners that can attack the plastic .
■
Never obstruct the ventilation openings .
■
Remove any adhering swarf with a brush .
NOTE
►
Unlisted replacement parts (such as carbon
brushes, switch) can be ordered via our
service hotline .
Emptying the dust bag
To ensure optimum dust extraction, empty the dust
bag regularly .
♦
Open the zip on the dust bag .
♦
Shake out the dust bag over a suitable waste
container .
Summary of Contents for 303200 1904
Page 3: ......
Page 4: ...A B ...
