PSTKA 12 A1
GB
│
MT
│
45
■
Charging time:
approx. 60 min
Fuse (internal):
2 A
T2A
Protection class:
II / (double insulation)
Noise and vibration data:
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically as follows:
Noise emission value:
Sound pressure level: L
pA
=
87.9 dB (A)
Uncertainty K:
K
pA
=
3 dB
Sound power level:
L
wA
=
98.9 dB (A)
Uncertainty K:
K
wA
=
3 dB
Wear hearing protection!
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Total vibration value:
Sawing chipboard a
h,B
= 13.6 m/s
2
Uncertainty K = 1.5 m/s
2
Sawing metal plate a
h,M
= 10.6 m/s
2
Uncertainty K = 1.5 m/s
2
WARNING!
►
The vibration emission values and noise
emission levels specified in these instructions
have been measured in accordance with the
standardised testing procedure specified and
can be used to make equipment comparisons.
The specified vibration emission values and
the noise emission values can also be used to
make an initial load estimate.
►
Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece that is being worked, the vibra-
tion and noise emission values can deviate
from the values given in these instructions
during actual use of the power tool.
NOTE
►
Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the power
tool is switched off and times where the
power tool is switched on but running without
load).
General Power Tool
Safety Warnings
WARNING!
►
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool.
Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. Work area safety
a)
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b)
Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust.
Power tools create sparks
which may ignite the dust or fumes.
c)
Keep children and bystanders away while
operating a power tool.
Distractions can cause
you to lose control.
Summary of Contents for 306438
