PHET 15 B1
GB
│
IE
│
13
■
5. Service
a)
Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts.
This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety instructions
for electric staple guns
■
Always check that the power tool contains
staples.
Careless handling of the electric staple
gun can lead to unexpected ejection of staples,
which could cause injuries.
■
Never aim the power tool at yourself or
other people in the vicinity.
Unintended trig-
gering will cause a staple to be shot out, which
can lead to injuries.
■
Do not activate the power tool until it is
pressed firmly against the workpiece.
If the
power tool is not in contact with the workpiece,
the staple can rebound off the fastening point.
■
Disconnect the power tool from the mains
or battery if a staple becomes jammed in
the power tool.
If the electric staple gun is
connected to a power source, it could be unin-
tentionally activated while removing a jammed
staple.
■
Be careful when removing a jammed staple.
The system may be live and the staple could be
forcefully ejected while you are attempting to
unblock the jam.
■
Never use this electric staple gun for
fastening electrical cables.
It is not suitable
for the installation of electrical lines, can dam-
age the insulation of electrical cables and thus
cause electrical shocks and increase the risk of
fire.
Supplementary notes
WARNING! RISK OF INJURY!
■
Never aim the appliance towards yourself or
other people or animals.
Ensure that no other people or animals are
on the other side of the workpiece or in the
immediate vicinity.
■
PROTECT YOUR EYES!
Wear safety goggles.
This also applies to people who are carrying
out support and holding work during operation.
■
Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■
Always guide the power cord away to the rear
of the appliance.
Original accessories/auxiliary
equipment
■
Only use the accessories and additional
equipment which are specified in the
operating instructions and compatible
with the appliance.
Operation
Filling the magazine
WARNING! RISK OF INJURY!
■
Switch the appliance off and remove the
power plug before starting any work on the
appliance.
♦
Turn the appliance around.
♦
Press the release together (see Fig. A).
♦
Pull the magazine backwards (see Fig. A).
♦
Fill the magazine shaft with staples or nails
(see Fig. B).
NOTE
►
Nails can only be inserted into the magazine
shaft from the left – as shown.
♦
After filling, push the release into the maga-
zine as far as the stop until it clicks into place.
NOTE
►
Use the fill level indicators , to see
whether the magazine contains staples or
nails.
Summary of Contents for 307142
Page 3: ...A B...
Page 45: ...PHET 15 B1 42 PL...
