17
GB
Press “Return / Clear“ button
8
multiple times to go back to
Home-screen (see chapter “Start-up“, section “Home-screen
mode“).
Note:
Pressing “Return / Clear“ button
8
under continuous
measurement mode will stop the measurement.
Selection of the reference point
The rear reference point
29
(base) or the end piece
28
reference
point or the front reference
30
point of the product can be used
as the contact surface for any measurement. The reference point is
to be set before measurement. Otherwise, the measured result dif-
fers from actual value. The default reference point setting is from
the reference point (rear)
29
of the product. The reference point
can be changed by pressing the reference button
12
repeatedly
until the desired reference point shown on the top left side corner
of the display.
End piece reference point
The end piece
33
will be useful while a distance is measured from
a corner (diagonal room) or from the place, where it is difficult to
reach. The end piece
33
is located on the rear side of the product.
The end piece
33
can be unfolded as shown in the fig D using a
sharp tool or finger nail. Once finished using, the end piece
33
has to be folded-back for future use.
