PFBS 160 B2
GB
│
MT
│
69
■
Router cage
With this attachment, the appliance is particularly
suitable for cutting special forms (holes for plugs,
etc .) .
♦
Insert the milling bit as described in the sec-
tion "Changing/inserting the tool/collet chuck" .
♦
Ensure that the shaft of the bit protrudes out of
the collet chuck by about 16 mm .
♦
Screw the union nut anticlockwise off the
appliance and store it carefully .
♦
Screw the router cage onto the appliance .
♦
To set the correct working height, undo the
locking screw and adjust the foot of the
router cage to the desired size .
♦
Afterwards, retighten the locking screw .
ca. 16 mm
Changing the batteries
♦
Make sure that the LED light is turned off .
Remove the three screws from the rear of the
grip ring with LED .
♦
Replace the used batteries in the appliance
with new batteries of the same type (button
cell LR41) . Note polarity when installing new
batteries .
♦
Close the battery compartment again by
replacing the three screws .
Cleaning, care and storage
WARNING! RISK OF INJURY!
■
Switch the appliance off and remove the
power plug before starting any work on
the appliance.
The appliance is maintenance-free .
■
Remove all dirt from the appliance . Use a dry
cloth to do this .
WARNING!
■
If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
avoid safety hazards .
■
Store the appliance and all the individual
pieces in the provided plastic case to ensure
you do not lose any part .
NOTE
►
Replacement parts not listed (such as the
rechargeable battery, battery charger) can
be ordered via our service hotline .
WARNING!
■
Always ensure that the power plug or the
mains cable is replaced only by the manu
facturer of the appliance or its customer
service.
This will ensure that the safety of the
appliance is maintained .
Summary of Contents for 332006 1907
Page 3: ...C A B 14b...
