49
GB/MT
Working with the tripod
Setup and alignment
1. Pull all the three legs
17
of the tripod apart. The plastic ring
15
,
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
16
and extend the legs until you get
your desired height.
3. Then, fold-back all those blocking levers
16
.
4. Check the straight positioning by using the bubble level
11
. If the
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
17
.
5. If additional height is necessary, loosen the locking screw
14
and
extend the centre column to desired height. Once reached the
desired height, tighten the locking screw
14
.
6. For a horizontal alignment of the tripod flat head
18
, loosen the
long handle
12
by turning anti-clockwise and move the handle up
or down as desired. If the air bubble of the spirit level
11
is located
exactly in the middle of the circle, the tripod flat head is aligned
horizontally. Then, tighten the long handle
12
by turning it clockwise.
7. If necessary, loosen the locking screw
13
to rotate the tripod flat
head
18
up to 360 degree horizontally to get desired side. Once
reached the desired side, tighten the locking screw
13
.
8. If necessary, loosen the locking screw
10
to adjust the angle of the
tripod flat head
18
up to 90 degree vertically to get desired angle.
Once reached the desired angle, tighten the locking screw
10
.
Securing the Cross Line Laser
Align -thread
6
of cross line laser with the -quick-release fixing
screw
8
of the quick shoe and make sure to tighten the screw well by
screwing the metal bracket
9
clockwise. The metal bracket
9
is on
the bottom side of the quick shoe
19
.
Removing quick shoe from tripod:
User can just remove the cross line laser together with quick shoe
19
from tripod by following below steps:
1. Pull the lever
11a
on the tripod flat head
18
along the side.
2. Remove the quick shoe
19
.
3. If want to put back the cross line laser on the tripod again, pull the
lever
11a
on the tripod flat head
18
and place the quick shoe
19
back firmly on the tripod flat head
18
. Then, release the lever
11a
to bring back to original position and to firmly hold the quick shoe
19
(see fig. A).
