11
GB/IE
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive (2012/19/
EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designated collection point.
This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electrical and electronic equip-
ment. Improper handling of waste equipment may have negative consequences for the environment and human health due to poten-
tially hazardous substances that are often contained in electrical and electronic equipment. By properly disposing of this product, you are also
contributing to the effective use of natural resources. You can obtain information on collection points for waste equipment from your municipal
administration, public waste disposal authority, an authorised body for the disposal of waste electrical and electronic equipment or your waste
disposal company.
16. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Possible cause
Remedy
Saw blade without pins
loosens after switching off
the engine
Saw blade clamping screw (28/29) not tightened
enough
Tighten the saw blade clamping screw (28/29)
Motor does not start
Failure mains fuse
Check the mains fuse.
Extension cable defect
Change extension cable.
Fine-wire fuse defective
Check the fine-wire fuse and, if necessary, replace it with
a fine-wire fuse of the same type.
Connections on the motor or switch defect
Have it checked by an electrician.
Motor or switch defect
Have it checked by an electrician.
Saw blades brake
Tension set incorrectly
Set correct tension
Load too high
Feed workpiece more slowly
Incorrect saw blade type
Use correct saw blades
Workpiece not fed straightly
Avoid lateral pressure
Saw blade oscillates, not
aligned straightly.
Holders not aligned
Open the screws that fasten the holders. Bring the hold-
ers into the vertical position and tighten the screws again.
Summary of Contents for 338352 2007
