Parkside 339966-1910 Translation Of The Original Instructions Download

Page: 36 / 147

PDFW 120 A2

■

│

Adjusting the tool rests

♦

Adjust the workpiece rests   with the aid of
the knurled screws  . Ensure that the space
between the grinding   or the buﬃng disc
and the tool rest   is as low as possible.
Ensure that the workpiece rests   do not come
into contact with the grinding   or the buﬃng
discs  .

♦

Adjust the distance repeatedly as the
grinding or buﬃng disc wears down.

Fitting the spark deﬂectors

♦

Fit the spark deﬂectors with the aid of the
ﬁxing bolts for the spark deﬂectors , nuts,
washers and spring washers to the top of the
device (see ﬁg. C).

♦

Tighten the nuts using a pair of pliers or a 7 mm
open end wrench. Tighten the ﬁxing bolts for
the spark deﬂector using a Phillips screw-
driver.

♦

Fit the spark deﬂectors   so that the distance
between the grinding   or buﬃng disc   and
the spark deﬂector   is as small as possible.
The gap should not be greater than 2 mm.
Ensure that the spark deﬂectors   do not come
into contact with the grinding   or the buﬃng
discs  .

♦

Adjust the distance repeatedly as the
grinding or buﬃng disc wears down.

Fitting the eye shields

♦

Attach the eye shields to the ﬁxtures provided
on the spark deﬂectors using the mounting
screws for the eye shields , nuts, washers and
spring washers (see ﬁg. C).

♦

Tighten the nuts using a pair of pliers or a 8 mm
open end wrench. Tighten the ﬁxing bolts for
the eye shields using a screwdriver.

Working procedures

Ensure that the appliance is always stable
and secure. For extra safety, you can secure
the appliance in a suitable location. There are
4 drill holes in the housing foot that can
be used for attachment to a secure and level
surface. Feed a suitable ﬁxing material that
is appropriate for the surface (not supplied)
through the 4 drill holes . Fix the appliance
to the surface using the ﬁxing material.

Ensure that the grinding and buﬃng
discs are not blocked.

Ensure that the eye shields , spark deﬂec-
tors

and tool rests are properly ﬁtted

and adjusted!

A light grinding pressure is suﬃcient

Work using a light grinding pressure – a constant
and correct speed will ensure the best grinding
performance.

Grinding

Bear in mind that the workpiece heats up during
grinding. Therefore, cool the workpiece in a water
bath. Dry it thoroughly before you resume working.

Operation

Switching on and oﬀ

■

Direction of rotation of the tool!

NOTE

►

Before ﬁrst use, allow the grinding   and
buﬃng discs   to run without a load at top
speed for about 5 minutes. When doing so,
stay out of the hazard area in front of and
next to the openings in the grinding   or the
buﬃng disc  .

WARNING! RISK OF INJURY!

►

Ensure the lowest-possible distance (gap)
between the grinding or the buﬃng
disc and the tool rest .

►

If the appliance suddenly brakes completely
or jams, it must be switched oﬀ immediately.

♦

Set the eye shields so that they provide the
greatest possible protection.