Parkside 345815 2001, Translation Of The Original Instructions

PMFS 200 C3

■ 

6 

│

GB

│

IE

│

NI

│

CY

Before use

Fitting/changing the sander plate

WARNING!

►

Always remove the plug from the mains 
power socket before carrying out any work 
on the appliance.

♦

Use the appropriate sander plate       for 
the corresponding application.

♦ 

Remove the four screws   using the supplied 
Phillips screwdriver  .

♦

Remove the pre-fitted sander plate.

NOTE

►

The orbital sander plate   can only be fitted 
to the appliance in one direction. Please pay 
attention to the arrow marks on the orbital sand-
er plate  . These must point forwards. With the 
delta sander plate   the tip points forwards.

►

The rubber pins   have a groove on the side. 
The groove must be aligned with the tabs in 
the mounting holes on the respective sander 
plate    . This allows you to insert the 
rubber pins   into the sander plate    .

♦

Now fit the required sander plate. Ensure that 
the mounting plate 

B

 is aligned with the sander 

plate. The threaded holes of the mounting plate 

B

 must be aligned with the corresponding holes 

on the respective sander plate. Align the rubber 
pins 

A 

 (only on sander plates   and  ) 

with the holes in the appliance (see fig. 1).

A

B

Figure 1

♦ 

Re-tighten the four screws   using the Phillips 
screwdriver  .

♦

Check that the sander plate is fitted securely.

Selecting a sanding sheet

Removal and surface:

The material removal rate and surface quality are 
determined by the grain strength of the sanding 
sheet. 

♦

Please note that you need to use appropriate 
sanding sheets with different grains for working 
different materials.

Fitting the sanding sheet

WARNING!

►

Always remove the plug from the mains 
power socket before carrying out any work 
on the appliance.

NOTE

►

Before fitting a new sanding sheet, remove any 
dust and dirt from the sander plate 

. 

Attaching sanding sheets using Velcro:

♦

You can attach the sanding sheet to the sander 
plate       using Velcro.

♦

Ensure that the extraction holes on the sanding 
sheet match up with those on the sander plate.

Removing sanding sheets fitted using Velcro:

♦

Simply pull the sanding sheet off the sander 
plate       (see fig. A on the fold-out page).

Attaching sanding sheets without using 
Velcro (see fig. B on the fold-out page, not 
supplied):

♦

Open the two clamping levers  .

♦

Push the sanding sheet under the open clamp-
ing rail   at one end and clamp it firmly in 
place with the clamping lever.

♦

Follow the same procedure at the other end.

IB_345815_PMFS200C3_GB-IE-NI.indb   6

19.08.20   12:02