PAEXS 20-Li A1
GB
│
MT
│
51
■
Dust box
Connecting
♦
Slide the dust box onto the appliance as far
as the stop .
Removal
♦
Pull the dust box off the appliance .
NOTE
►
To achieve optimum dust extraction, the dust
box should be emptied regularly .
♦
To do this, remove the dust box from the
appliance as described above . Open the dust
box by pulling on the tab and then removing
the lid . Clean both parts thoroughly by tapping .
Reducer
Connecting
♦
Push the reducer for external extraction appli-
ances into the adapter fitting .
♦
Push the hose from a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the reducer for external extraction appli-
ances
.
Removal
♦
Pull the hose of the vacuum cleaner off the
reducer for external extraction appliances
.
♦
Remove the reducer .
Use
NOTE
►
Always switch on the appliance before contact
with the material and then apply the tool to the
workpiece .
Adjusting the additional handle
You can adjust the additional handle to several
different positions .
♦
To reposition the additional handle undo
the screw .
♦
Move the additional handle to the required
position .
♦
Retighten the screw .
Switching on and off
Switching the appliance on
♦
Move the ON/OFF switch to the "I" position .
Switching the appliance off
♦
Move the ON/OFF switch to the "0" position .
Setting the rotational speed
♦
Adjust the speed setting wheel to a position
between 1 and 6 .
Working procedures
■
Switch the appliance on before applying it to
the workpiece .
■
Apply minimal pressure when working .
■
Work at a constant speed .
■
Change the sanding sheets regularly .
■
Never use the same sanding sheet for sanding
different materials (e .g . wood followed by
metal) . Optimum sanding results can only be
achieved by using clean sanding sheets .
Summary of Contents for 351737 2007
Page 3: ...A ...