PDAP 75 A1
GB
│
IE
│
9
■
Hazards caused by accessories
■
Disconnect the sander or the polisher from the power before
changing the tools or accessories.
■
Avoid direct contact with the machine tool during and after use,
since this can have heated up or have become sharp.
■
Use only tools for sanders and polishers which have been ap-
proved by the manufacturer of the sander and polisher.
■
Cutting discs and machines for cutting may not be used.
■
Check whether the maximum operating speed of the tool
(stitched buffs, abrasive belts, fibre discs, etc.) is higher than that
of the machine;
■
Self-adhesive grinding discs must be applied concentrically on
the mounting plate.
Hazards in the workplace
■
Slipping, tripping up and falling are the main causes of injuries
in the workplace.
Take note of surfaces which could have be-
come slippery through use of the machine, and also any tripping
hazards caused by air or hydraulic hoses.
■
These sanders and polishers are not suitable for use in explosive
environments and are not insulated against contact with power
sources.
■
Do not operate the appliance in the vicinity of electric mains,
gas pipelines etc. which could pose a hazard if damaged by the
machine.
Summary of Contents for 354115 2010
Page 3: ......
