Parkside 356373 2007 Assembly, Operating And Safety Instructions Download

Page: 8 / 83

8 GB

Keep spraying requirement away from children
and young persons under 16.

Do not leave the device unattended while it is
in operation. Use the device as intended!

Secure the device during

transport to prevent the spray liquid escaping.

Examine the product before

each use, ensure it is free of damages, con-
gestions and all parts work as intended. Rubber
parts such as the hoses or O-rings must not
show any cracks or appear porous. Pay par-
ticular attention to the safety devices. Ensure
all connections are fitted tightly.

Examine the product before first use after winter.

CAUTION:

Do not use the product if any

visible damage or loss of functionality.

Always place the device on an even, flat surface.

During the sprayer is being

filled, adjusted, used, transported, emptied,
cleaned or maintained. Protect yourself with
suitable personal protective equipment (PPE).

Wear eye protection ( goggles or face shield )

Wear respiratory protection and appropriate
protective clothing

Wear water-proof glove and rubber boots

Read the instruction handbook

Keep bystanders away when spraying

Only use spare parts and

accessories provided by the manufacturer
(pls. follow the step of “Exchange of spare
parts included“ described in the manual). All
other repairs shall only be carried out by the
manufacturer, its service agent or similarly
qualified persons. Improper maintenance can
lead to a hazardous situation.

Wash your hands and face after each spray-
ing session.

In case of intoxication via skin contract, please
rinse with water immediately and consult doc-
tor advice.

CAUTION! RISK OF
EXPLOSION!

Do not place the

device (empty or full) in direct sun-

light and frost.

Always read and observe the information pro-
vided by the chemical manufacturer when
working with or mixing spray solutions.

Only mixing and filling the sprayer outdoors
or in well-ventiled greenhouse.

All the applicant and liquid for the device
shall not over 40°C and refer to the informa-
tion provided by chemical manufacturer.

Never mix more spray solution / pesticide then
is required. Do not dispose of residues in the
drains. Disposal shall follow the safety intro-
duction according to chemical manufacturer.

Do not exceed the nominal

volume! Ensure the liquid to be sprayed is
compatible with the product. Ensure that the
use of the pesticide, liquid fertiliser or clean-
ing agent is permitted in your country.

Do not store the device in

livestock buildings due to the ammonia vapours
(danger of brass cracking), do not fill with
solutions containing nitrogen or phosphates.

Do not store spraying pesticides in the device.

Never spray into wind, water, or drinking water
source. Never spray at human or animals.

Take into account of wind, rain

and other climate and environmental conditions
to avoid hazard of uncontrolled or unintended
liquid distribution. Avoiding drift during spraying
operation.

Do not use device when any leakages, uneven
spray jet.

Release the residual pressure after each use.

Before each use, pls. ensure the device is in
good condition. Pay attention to the tightness
of the screw connection and appearance of
the device. If damage is suspected and leakage
found, take out of the operation immediately.

Do not blow out blocked nozzles using the
mouth.

The sprayer may not be used if the operator is
tired, ill or under influence of alcohol, drugs
or medication.

Procedure after accidents:

If you contact with

the spray solution or the blockage of spraying
occurs after pressurized, release the pressure
sprayer immediately by unlocking the belt
hook

and sliding the pressure sprayer

down the floor.

Danger to health due to con-

tact with the plant protection products! Plant
protection products may cause damage to