PAFS 550 A1
GB
│
IE
│
9
■
WARNING! HAZARDS CAUSED
BY MATERIALS AND SUBSTANCES!
►
There is a risk of coming into contact with or
absorbing coating materials and/or cleaning
fluids . There is also a risk of inhaling vapours
from liquids . This can cause permanent dam-
age under certain conditions .
►
Always wear personal protective equipment
when working on the appliance!
►
Ensure sufficient technical or natural ventila-
tion .
►
Follow the manufacturers’ safety instructions
for the respective coating materials and
cleaning liquids .
►
If you experience any symptoms, seek medi-
cal advice!
Working procedures
NOTE
►
Ensure that the spray material and thinning
agent are compatible . Using an unsuitable
thinning agent may cause clots that clog the
appliance .
►
To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material .
►
Granular products and products containing
solids must not be sprayed . Their abrasive
effect will shorten the service life of the
appliance .
Preparing the spray surface
WARNING!
►
Risk of electric shock due to penetrating spray
material! Be sure to mask any sockets and
switches .
♦
Cover any surfaces around the spray area ex-
tensively and thoroughly . Any surface that is
not masked could become contaminated .
♦
Make sure that the spray surface is clean, dry
and free of grease .
♦
Polished surfaces should be lightly sanded and
the sanding dust removed .
Spraying technique
♦
Always hold the paint spray gun at the same
distance and at a right angle to the object . The
ideal spraying distance is approx . 20–25 cm .
Move the paint spray gun evenly with your
whole arm (see fig . J) .
♦
Determine the appropriate settings in each
case by experimenting, e .g . on a piece of
cardboard .
♦
Do not switch the appliance on/off above the
spray area, but start and stop the spraying
process approx . 10 cm outside the spray area .
Before use
Assembly
NOTE
►
You can assemble the appliance using two
adjustable spanners (not supplied) .
►
Alternatively, you can also use a 16 mm and
19 mm wrench
(not supplied) .
♦
Fit the high-pressure hose
w
onto the connect-
ing thread
r
on the appliance . Tighten the nut
using an adjustable spanner . Counter the nut
of the connection thread
r
with a second ad-
justable spanner (see fig . A) .
♦
Fit the other end of the high-pressure hose
w
to the connecting thread of the paint spray
gun
0
. Tighten the nut using an adjustable
spanner . Counter the nut of the connection
thread of the paint spray gun with a second
adjustable spanner .
Selecting/changing the nozzle
Nozzle
Use
Nozzle 311
low viscosity spray material
Nozzle 517
viscous spray material
♦
Insert the corresponding nozzle
5
with the
arrow tip in the spraying direction into the
nozzle chamber
p
.
Summary of Contents for 360098 2010
