PAFS 550 A1
GB
│
IE
│
11
■
Settings
♦
You can use the pressure regulator dial
3
to
switch the appliance on by setting a level greater
than 0 . The level you choose depends on the
spray material used . Determine the best setting
by carrying out a spray test .
♦
The function switch
e
has two settings:
–
1. PRIME
(vertical position):
This setting allows you to pre-fill the system
with paint or to depressurise the appliance .
–
2. SPRAY
(horizontal position):
You can use this setting to work with the
appliance .
Spraying
♦
Unlock the paint spray gun
7
by turning the
safety catch
6
so that its tip is facing down .
♦
To spray, press the trigger
9
and hold it down .
♦
To stop spraying, release the trigger
9
again .
WARNING!
►
Always secure the paint spray gun
7
while
you are not actually spraying .
♦
Lock the paint spray gun
7
by turning the safety
catch
6
with the tip as far back and up as
possible .
Overheating protection
The appliance has an overheating protection .
It switches the appliance off if overheating is
imminent . If this happens, carry out the following
steps:
♦
Turn the pressure regulator dial
3
to position 0
(off) .
♦
Turn the function switch
e
to the vertical
position (PRIME) .
♦
Let the appliance cool down for at least
30 minutes and, if necessary, remove the cause
of the overheating . This could be, for example,
an item that is covering the ventilation slots or if
the appliance is too close to a wall .
♦
Put the appliance back into operation .
Depressurising the appliance
Always depressurise the appliance when you want
to take it out of operation . Depressurise the system
as follows:
♦
Turn the pressure regulator dial
3
to position 0
(off) .
♦
Turn the function switch
e
to the vertical posi-
tion (PRIME) .
♦
Unlock the paint spray gun
7
by turning the
safety catch
6
so that its tip is facing down .
♦
Release the pressure by pulling the trigger
9
.
Hold the paint spray gun
7
over an empty
container while doing so .
♦
Wait until all pressure and paint has been
dispelled from the system . To stop spraying,
release the trigger
9
again .
♦
Lock the paint spray gun
7
by turning the safety
catch
6
with the tip as far back and up as
possible .
Summary of Contents for 360098 2010
