11
GB
Winding/unwinding the cable
(Fig . J)
Winding the cable: Press the control
switch
[
8]
upwards according to the arrow
indication .
Unwinding the cable: Press the control switch
[
8]
downwards according to the arrow
indication .
Lifting loads
Lower the steel cable
[
14]
so you can handle it
comfortably .
Fasten the load to the hook
[
10]
[
12]
. Use
additional bungee cords where necessary .
The load’s centre of gravity must be beneath
the product .
Wind up the steel cable
[
14]
until it is only taut .
Then fully lift the load .
Maximum/minimum length
levers
NOTE
u
The maximum/minimum length levers
[
15]
[
16]
are not intended to regularly stop the
product . Always attempt to stop the product
before it triggers one of these levers .
Minimum cable length lever
When the steel cable
[
14]
is fully wound up, the
minimum cable length lever
[
15]
will be triggered .
The steel cable cannot be wound up any further . It
can only be unwound .
Maximum cable length lever
When the steel cable
[
14]
is fully unwound, the
maximum cable length lever
[
16]
will be triggered .
The steel cable cannot be unwound any further . It
can only be wound up .
Emergency off switch
(Fig . J)
In case of an emergency, press the
emergency off switch
[
7]
to stop lifting or
lowering operation .
The product is then locked . To unlock the
product, turn the emergency off switch
[
7]
slightly clockwise (in the direction of the
arrow) until it pops out .
Set-up as block and tackle
Accessories
The following tools are needed for the safe and
proper use of the block and tackle function:
2 spanners (8 mm)
2 spanners (13 mm)
m
WARNING
u
Do not use any accessories not
recommended by Parkside .
Setting up the product as a block and tackle
distributes the load to 2 pulleys . This allows twice
the weight to be lifted . However, the maximum
lifting height and speed are reduced by half .
Fasten the hook
[
12]
to the intended mounting
opening
[
18]
. The steel cable
[
14]
now forms a
loop (Fig . C) .
Dismantle the pulley
[
11]
of the extra hook:
Remove the 3 screws (Fig . F) .
Summary of Contents for 373100 2104
