12
GB
NI
CY
If necessary, you can connect the
suction hose of a vacuum cleaner
directly onto the angle adapter.
Operation
Before initial operation, perform a trial run
at top speed without a load for at least 1
minute. Remain outside the hazard area
while doing so.
Switching on and off
Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device‘s type
plate.
Connect the machine to the power
supply.
1. Select the desired speed using the
speed regulator (2).
Switching on:
2. Press the power switch “
I
” (3), the de-
vice starts.
Switching off:
3. Press the off switch „
O
“ (3), the device
turns off.
4. Next, remove the mains cable (5) from
the wall socket.
After switching on the device, wait until the
device has reached its max. speed. Only
then may you commence sanding.
Sanding
The arrow
above the sanding disc
(
A
1) indicates the direction of rotation of
the disc sanding device.
The sanding speed can be regulated using
the speed regulator (
A
2).
Mounting horizontally (
):
• Place the workpiece on the sanding
table (11) and slowly bring it to the de-
sired angle
towards the left half
of the
sanding disc (
A
1).
Mounting vertically (
):
• Slowly bring the workpiece to the de-
sired angle towards the sanding disc
(
A
1).
Cleaning
Pull the mains plug before any ad-
justments, maintenance or repair.
Do not use any cleaning agents or
solvents. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
Have any work on the device
that is not described in this in-
struction guide performed by a
professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken. There
is a risk of burning!
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Remove chips, dust and dirt, i.e. with a
brush.
Summary of Contents for 373869 2104
Page 3: ...1 11 2 3 5 4 6 7 8 9 10 4 12 13 14 15 16 17 4 16 18 1 13a 13b 19 4 16 2 ...
Page 50: ...14 15 ...
Page 51: ......