Parkside 385679 2107, Translation Of The Original Instructions

PHP 500 E3

■ 

4 

│

GB

│

IE

│

NI

Using the appliance

Mains operation

♦

Connect the power cable 

q

 to the mains 

connection of the glue gun 

0

 (see fig . A) . Insert 

the power plug into the socket . The control lamp 
for the mains connection 

2

 lights up .

♦

Fold down the plastic stand 

6

 . Put down the 

appliance .

♦

Push a glue stick into the feeder shaft 

1

 .

♦

Allow the appliance to heat up for about  
2 minutes . The appliance is now ready for use .

Cordless operation

♦

Connect the power cable 

q

 to the mains 

connection of the table station 

3

 . Insert the 

power plug into the socket .

♦

Place the glue gun into the table station 

4

 .  

The control lamp for the mains connection 

2

lights up .

♦

Push a glue stick into the feeder shaft 

1

 .

♦

Allow the appliance to heat up for about  
2 minutes . The appliance is now ready for use .

♦

Repeat the heating phase if the glue is still too 
thick or viscous .

Gluing

♦

Pull the trigger 

5

 to control the flow of glue in 

accordance with your requirements .

♦

Apply the glue in spots . For flexible materials, 
such as textiles, apply the glue in zigzag lines .

♦

Press the two workpieces to be bonded together 
immediately after applying the glue and hold 
for about 30 seconds . The glued bond is ready 
after about 5 minutes .

♦

During breaks in work, put the glue gun down 
on the plastic stand 

6

 or replace it in the table 

station 

4

 .

♦

Remove any glue residue after it has cooled 
down with a sharp knife . Bonded joints can be 
released by heating .

Switching the appliance off

♦

Unplug the appliance from the mains socket .

Maintenance and cleaning

 WARNING! ALWAYS REMOVE THE 
POWER PLUG FROM THE POWER 
SOCKET BEFORE CLEANING THE 
APPLIANCE.

■

The glue gun is maintenance free .

■

Keep the appliance clean and dry at all times .

■

Never permit liquids to enter inside the appli-
ance . Use a cloth to clean the housing . Never 
use petrol, solvents or cleansers which can 
damage plastic .

Disposal

The packaging is made from environ-
mentally friendly material and can be 
disposed of at your local recycling 
plant .

Do not dispose of power tools  
in your normal domestic waste!

As required by European Guideline 
2012/19/EU, worn-out electrical 

appliances must be collected separately and fed 
into an environmentally compatible recycling 
process .
Your local community or municipal authorities can 
provide information on how to dispose of the 
worn-out appliance .

Dispose of the packaging in an envi-
ronmentally friendly manner . Note  
the labelling on the packaging and 
 separate the packaging material 

components for disposal if necessary . The pack-
aging material is labelled with abbreviations (a) 
and numbers (b) with the following meanings: 
1–7: plastics, 20–22: paper and cardboard, 
80–98: composites .

Your local community or municipal 
authorities can provide information on 
how to dispose of the worn-out product .