10
GB/IE/NI
Before using the device
1. Fit the connector
5
onto the nozzle
19
of the pump
1
, as shown in Fig. F.
2. Depending on the height required, fi t the short socket pipe
3
or one or more socket pipes
2
onto
the connector
5
(see Fig. G + H).
3. Select one of the fountain attachments
6
–
10
and fi t it onto the socket pipe
2
(see Fig. I).
4. You can change the shape of the fountain with the modifi ed attachment
9
with one of the fl at
attachments
11
–
13
(see Fig. B3).
5. Connect the pump cable
14
to the cable of the solar panel
15
. To do this connect the two plugs and
tighten the lock handtight (see Fig. J).
PLEASE NOTE:
Prevent the pump from running dry. Failure to do so will void any warranty and
liability claims.
Using the device
Check whether the position for the pump
1
is secure and fi x the pump
1
onto the supporting
surface before you use it. For smooth supporting surfaces, you can use the suction pads on the
underside of the pump
1
to do this.
Position the pump
1
fully below the surface of the water, ideally at least 4 cm under the water level.
Align the pump
1
so that it is as level and horizontal as possible.
Do not place the pump
1
directly onto slimy or sandy surfaces. The ideal position is for it to be
raised, such as, for example, on a stone.
Never use the pump
1
without the fi lter grille
21
. This prevents the ingress of coarse dirt which
would damage the pump
1
.
In order to achieve the very best pumping results, the pump
1
must be positioned on a fl at surface.
Only allow the pump
1
to operate when it is completely submersed in water.
If you use the pump
1
in an ornamental pond, position the pump
1
in an area which is as free of
sand as possible.
Now position the solar panel
4
in such a way that it is in full sunlight. For better alignment, the
stands
16
can be folded out or alternatively, the solar panel
4
can be fi tted to the suspension holes
17
provided for this purpose.
PLEASE NOTE:
In order to achieve the maximum water fl ow, the solar panel
4
should be
positioned in an area with direct, all-day sunlight and not in shadow.
PLEASE NOTE:
You can position the pump
1
to a depth of approx. 17 cm below the surface
of the water. The selected fountain attachment
6
–
10
must always be above the surface of the water,
even where there are light waves, so that the jet spouts properly.
Maintenance and cleaning
The pump
1
has been manufactured in a reliable, high-quality design, where the non-contact pump
wheel mechanism ensures a long period of operation. However the fan wheel unit
18
is susceptible to
contamination from the operating environment and must not be damaged.
CAUTION:
In order to clean the pump
1
or carry out maintenance work, always disconnect it
from the solar panel
4
fi rst. There is a risk of electric shock or risk of injury through moving parts.
388428_2107_Solarteichspringbrunnen_content_LB6.indb 10
388428_2107_Solarteichspringbrunnen_content_LB6.indb 10
22.11.21 12:18
22.11.21 12:18
