Parkside 40W PSCD 1 A1, Operation And Safety Notes

10  GB/IE

   Scope of delivery

Check immediately after unpacking that the parts are 
complete and that the product is in proper condition. 

1 LED spotlight
1 Instructions for use

 General  safety   

instructions

BEFORE USING THE PRODUCT, PLEASE FAMIL-
IARISE YOURSELF WITH ALL OF THE SAFETY 
INFORMATION AND INSTRUCTIONS FOR USE! 
WHEN PASSING THIS PRODUCT ON TO OTHERS, 
PLEASE ALSO INCLUDE ALL THE DOCUMENTS!

DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS 
AND SMALL CHILDREN!

 Never 

leave children unattended with the packaging 
material. The packaging material represents a 
danger of suffocation. Children frequently under-
estimate the dangers. Please keep the product 
out of the reach of children at all times.

This product may be used by children age 8 years 
and up, as well as by persons with reduced 
physical, sensory or mental capacities, or lack-
ing experience and / or knowledge, so long as 
they are supervised or instructed in the safe use 
of the product and understand the associated 
risks. Children should not be allowed to play with 
the product. Cleaning and user maintenance 
should not be performed by children without 
supervision.

 DANGER OF SUFFOCATION!

 Children could 

swallow and choke on small included parts (e.g. 
screws). Keep children away from the work area 
during assembly.

   The LED cannot be replaced. If the LED fails  

at the end of its life, the entire product must  
be replaced.

   The mains cable of this product cannot be  

replaced; if the mains cable is damaged, the 
product shall be destroyed.

Danger to life  
by electric shock

   Always check the product for damage before 

connecting it to the mains. Never use the product 
if it shows any signs of damage.

   Protect the mains cable against sharp edges, 

mechanical stresses and hot surfaces.

   Always unplug the mains plug from the mains 

socket before installation, dismantling or cleaning.

   Disconnect the product from the mains supply  

if it is not going to be used for some time (e.g. 
holiday).

   Prior to installation, verify that the mains voltage 

on site corresponds with the operating voltage 
required for the product (230 V∼ 50 Hz). Other-
wise do not install the product.

CAUTION! DANGER OF BURN INJURIES!

To prevent burns, verify the product is switched 
off and has cooled down for at least 15 min 
before touching it. The product can become 
very hot.

1 .0 m

FIRE HAZARD!

 Fit the product so 

that it is at least 1.0 m away from the 
material to be illuminated. Excessive 

heat can result in a fire.

CAUTION! RISK OF INJURY! 

Broken lamp glass must be replaced 
before any further use is made of the 

product.

   The product is only suited for use with the built-in 

LED control gear.

   The product continues to draw a small amount 

of power even if the product is off as long as 
product is connected to supply mains. To switch 
the product off completely, unplug the mains 
plug 

5

 from mains socket.

   Never direct the LED light beam on to reflective 

surfaces or at people or animals. Failure to ob-
serve this advice may result in eye injury and /  
or loss of sight to people or animals. Even a weak 
LED light beam can cause eye damage.

The product is not suitable be used as a hand 
held luminaire. Do not handheld the product 
when it is in operation.

Only mount the spotlight 

2

 on the supplied 

stand 

4

. Do not directly mount the spotlight 

2

on another surface, e.g. concrete wall or metal 
frame, etc.