Parkside 499896 2204 Original Instructions Manual Download

Page: 9 / 253

PWBS 180 B3

│

■

Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may aﬀect the
power tool’s operation. If damaged, have the
power tool repaired before use.

Many acci-

dents are caused by poorly maintained power
tools.

Keep cutting tools sharp and clean.

Properly

maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.

Use the power tool, accessories and tool bits,
etc., in accordance with these instructions,
taking into account the working conditions
and the work to be performed.

Use of the power tool for operations diﬀerent
from those intended could result in a hazardous
situation.

5. Service

Have your power tool serviced by a qualiﬁed
repair person using only identical replace-
ment parts.

This will ensure that the safety of

the power tool is maintained.

Always arrange for the replacement of the
plug or the power cord to be carried out by
the manufacturer of the appliance or by his
approved customer services.

This will ensure

that the safety of the power tool is maintained.

Safety instructions for all applica-
tions

General safety instructions for grinding and
sandpaper sanding

(a)

This power tool is intended for use as a grinder
and sandpaper sander. Please follow all safety
instructions, instructions, diagrams and data
that you receive with the appliance.

Failure to observe the following instructions can
lead to an electrical shock, ﬁre and/or serious
injuries.

This power tool is not suitable for working with
wire brushes, polishing and cut-oﬀ grinding

Using the power tool for applications for which it
is not designed can lead to hazards and injuries.

Do not use any accessories that have not
been speciﬁcally provided or recommended
by the manufacturer for this power tool.

Just

because you can attach the accessories to your
power tool does not guarantee they are safe to
use.

The maximum speed of the accessory tool
used must be at least as high as the maximum
speed speciﬁed for the power tool.

Accesso-

ries which rotate faster than the maximum
permissible rate can break and throw pieces
into the air.

The external diameter and thickness of the
accessory tool used must comply with the
dimensions of the power tool.

Incorrectly

dimensioned accessory tools cannot be suﬃ-
ciently shielded or controlled.

Attachment tools with a thread insert must
match the thread of the grinding spindle
exactly. For attachment tools that are
mounted using a ﬂange, the diameter of the
hole on the attachment tool must correspond
to the width of the ﬁtting on the ﬂange.

Acces-

sory tools that cannot be ﬁrmly ﬁtted to the
power tool rotate unevenly, vibrate severely and
can lead to a loss of control.

Never use damaged accessory tools. Before
each use, check tools such as grinding discs
for chipping and cracks, grinding discs for
cracks, wear or heavy wear. If the power tool
or the accessory tool in use is dropped, check
to see if it is damaged or use an undamaged
accessory tool. When you have checked and
inserted the accessory tool, ensure that you
and any other people in the vicinity remain
outside of the level of the rotating accessory
tool and allow the tool to rotate at maximum
speed for one minute.

Damaged accessories

usually break during the test period.