9
GB
General safety advice for electrical power tools
Additional safety … / Additional safety information for routers / Operation
Additional safety information
for grinders and polishers
POISONOUS DUSTS!
The working of mate-
rials that can produce harmful / toxic dusts
presents a health risk for the operator and for
people located in the close vicinity.
Avoid sanding of paints containing lead or other
material detrimental to your health.
Do not work on materials containing asbestos.
Asbestos is considered carcinogenic.
Wear safety glasses and a dust protection mask!
Additional safety information
for routers
Hold the device by the insulated handle
surfaces as there is a danger of the
cutter striking the device’s mains
lead.
Contact with a live wire could cause
metal parts of the device to become live and
lead to electric shock.
Only use cutting bits with the correct size shaft
diameter suitable for the speed of the electric tool.
Fix and secure the work piece to a
stable surface using clamps or other
means.
If you only hold the work piece with
your hand or against your body, it will remain
unstable which could lead to a loss of control.
Operation
Never use the device for any purpose other than
the intended purpose and only use it with the origi-
nal parts and accessories. The use of parts or ac-
cessories other than those recommended in the
operating instructions could lead to you suffering
an injury. Use only an extension cable that has
been completely unrolled and is undamaged with
a capacity of at least 5 A.
WARNING:
Do not use this tool for the creation
of notches in the vicinity of installations or openings
with live electric cables or in walls behind which
live electric cables could potentially be laid. The bit
could conduct electricity into the tool and this could
involve the risk of electric shock to the operator.
Trigger the circuit breaker or remove the fuse in
order to disconnect the relevant electric circuit.
Attention:
Always hold the tool on the plastic
housing and always wear safety goggles when
working with the tool.
Switching ON / OFF (see Fig. A)
Switching on:
Press the ON / OFF switch
4
.
Switching off:
Release the ON / OFF switch
4
.
Setting the speed (see Fig. B)
Turn the speed controller
2
in a clockwise
direction to increase the speed.
Turn the speed controller
2
in an anticlockwise
direction to reduce the speed.
Changing tools (see Fig. C)
Note:
Only use combination cutter accessory
parts with a shaft diameter of ø 4.8 mm.
Hold the spindle lock button
11
pressed down.
Loosen the clamping nut
10
with the wrench
14
by turning in an anticlockwise direction.
Change the tool.
Block the spindle lock, tighten the clamping
nut
10
using the open-ended spanner
14
.
Bits:
The bits included are intended for the following
applications (see Fig. D).
Multi-purpose cutter (HSS)
18
:
Application: wood, particle board, plastic, alumini-
um and iron sheets
Slot cutter (HSS)
17
:
Application: wood, particle board, plastic
Sanding belts
16
:
Application: sanding wood
Summary of Contents for 93497
Page 3: ...A C 11 1 12 12 10 9 7 5 4 2 3 13 8 G H 6 E B 2 10 7 D 15 14 19 I 19 F 16 4 5 18 17 13 10 8 11...
Page 4: ......
Page 22: ...22...
Page 50: ...50...
