Parkside 93549, Operation And Safety Notes

6  GB/IE/CY

Damaged or tangled cables increase the risk 
of an electric shock.

   If   the   mains   power   cable   of   this   appliance   is  

damaged,   it   must   be   replaced   by   the   manufac-
turer   or   its   service   department,   or   a   similarly  
qualified   person   to   prevent   hazards.

 Use in weather protected rooms only

Unplug if you will not be using the device for 
more than 30 minutes.

Let the device completely cool down after use 
and before storing.

 Do not use on material containing asbestos. 

 Avoid the risk of injury and burns as 
well as heath hazards:

Risk of burning!

The glue and the nozzle 

reach over plus 105 °C. 
Do not touch the nozzle or the glue. Do not let 
the hot glue touch people or animals. If there 
is contact with skin immediately put the affec-
ted area under cold running water for several 
minutes. Do not try to remove the glue from 
your skin.

Always run the power cable away from the 
appliance to the rear.

  original  accessories / tools

Use only the accessories and attachments  
detailed in the operating instructions, or those 
which are compatible with the device.

Start-up

prepare the area to be glued:

Do not use any flammable solvents to clean the 
area.

The room temperature and the temperature of 
the material to be glued may not be colder 
than +5 °C and no warmer than + 50 °C.

The area must be clean, dry and grease free.

Smooth out the surface before gluing.

Warm up cooled material such as e.g. steel for 
a better join.

1.   Fold the stand leg 

4

 out. Set the device aside.

2.   Put a glue cartridge in the feed canal 

1

.

3.   Let the device warm up for 5 minutes. The  

device is now ready to use.

Gluing:

Press the feed trigger 

3

 to start and control 

the flow of glue.

1.   Apply the glue in dots. Apply the glue in a  

zigzag line on flexible material e.g. textiles.

2.   Press both glued together work-pieces together 

immediately after applying the glue for ap-
prox. 30 seconds. The glued area is resilient 
after approx. 5 minutes.

3.   Place the glue gun on its stand leg 

4

 between 

gluing.

Switching the device off:

Pull the mains plug from the socket.

Maintenance and Cleaning

The low temperature glue gun is maintenance free.

WARnInG! 

Unplug the mains plug from the 

socket before cleaning.

Always keep the device clean, dry and free of 
oil or grease.

Do not allow liquids to enter the equipment. 
Please use a soft cloth for cleaning the 
housing. Never use petrol, solvents or cleaning 
agents that attack plastic.

Service

Have your appliance 

repaired by qualified specialist per-
sonnel using oeM parts only.

 This will 

maintain the safety of the device.

 If the plug or mains 

lead needs to be replaced, always 
have the replacement carried out by 
the manufacturer or its service centre.

This will maintain the safety of the device.

note: 

Spare parts not listed (e.g. carbon brushes, 

switches) can be ordered through our call centre.

Safety  instructions / Start-up / Maintenance  and  Cleaning / Service

Warranty / Disposal