Parkside 96899, Operation And Safety Notes

7 

GB/CY

Introduction / Safety of the fastener driving tool

In correspondence with conditions at the work loca-
tion, individual noise reduction measures may need 
to be carried out, such as placing the workpiece on 
a noise-suppressing surface, clamping or covering 
to prevent workpiece vibration and adjusting to the 
minimum pressure required by the work process. In 
certain cases, wearing personal hearing protection 
is require.

Wear hearing protection!

Vibration values in accordance with  
ISO 8662-11:1999:

Vibration emission value a

h,W

  =  15.0 m / s

2

Uncertainty  K  =  0.29 m / s

2

Mechanical impact (vibration)

The vibration value for the fastener driving device was 
determined in accordance with ISO 8662-11:1999 — 
Hand-held portable power tools – Measurement of 
vibrations at the handle — Fastener driving tools  
(see technical data). The value is referenced to the 
device and does not represent the influence on the 
hand-arm system when the device is used. Influence 
on the hand-arm system when using the device de-
pends on e.g. gripping force, pressing force, work-
ing direction, air pressure set, the workpiece and its 
position.

   Safety of the fastener  

driving tool

Please read 

all the safety information and 
instructions. 

Failure to comply with 

the safety instructions and instructions can result in 
severe injuries and / or damage to property.

PLEASE RETAIN ALL SAFETY INFORMATION 
AND INSTRUCTIONS FOR FUTURE REFERENCE.

Each time before starting work, check 
for flawless functioning of the safety 
and triggering devices as well as the 
firm fit of all bolts and nuts.

Do not conduct any improper manipu-
lation of the fastener driving tool.

Do not dismount or block any part of 
the fastener driving tool, such a trig-
ger lock.

Do not conduct any „emergency re-
pairs“ with unsuitable materials.

The fastener driving tool must be reg-
ularly and properly maintained as 
specified by the manufacturer.

Prevent anything that would weaken 
or damage the device, e.g. by: 
– stamping or engraving,

–  alterations not permitted by the  

manufacturer,

–  guiding on templates made of hard 

material, e.g. steel,

 – 

 permitting to fall onto or slide across 
the floor,

– using as a hammer,

– every type of external force.

Work safety

Never point a fastener driving tool that 
is ready to use directly at yourself, 
other persons or animals.

During work, hold the fastener driving 
tool so that head and body can not be 
injured by possible kickback due to a 
fault in the power supply or from hard 
places in the workpiece.

Never trigger the fastener driving tool 
into empty space. 

Following this instruction 

will prevent danger due to uncontrolled flying 
fasteners and overloading the device.

Before transporting, disconnect the 
fastener driving tool from the com-
pressed air network, particularly when 
using ladders or are moving with an 
unaccustomed body posture.

At the workplace, only carry the fas-
tener driving tool by its grip and never 
with the trigger actuated.

Pay attention to workplace conditions.

Fasteners may strike completely through thin 
workpieces or slide off corners or edges to 
cause a danger to persons.

Introduction