Parkside 96899, Operation And Safety Notes

8  GB/CY

Preparing the product for use / Operation

Safety of the fastener driving tool / Preparing the product for use

Use suitable personal protection equip-
ment, e.g. hearing and eye protection.

Wearing personal protective devices such as 
dust mask, non-slip safety shoes, safety helmet 
or hearing protectors, depending on the type 
of fastener driving tool and its application, re-
duces the risk of injuries.

Additional safety information 

for compressed air tackers

RISK OF INJURY!

Never  

 exceed the maximum permissible operating 
pressure of 8 bar. Use a pressure reducer to 
adjust the operating pressure.

RISK OF INJURY!

Never 

 use oxygen or other flammable gases as ener-
gy source.

Keep your working area clean and 
well lit.

Untidy or poorly lit working areas 

can lead to accidents.

Keep children and other individuals 
away from the fastener driving tool 
during use. 

Distractions can cause you to 

lose control of the device.

Remain alert at all times, watch what 
you are doing and always proceed with 
caution when working with a fastener 
driving tool. Do not use any fastener 
driving tool if you are tired or under the 
influence of drugs, alcohol or medication.

One moment of carelessness when using the fas-
tener driving tool may result in serious injuries.

Avoid placing your body in an unnat-
ural position. Keep proper footing 
and balance at all times.

By doing this you 

will be in a better position to control the fas-
tener driving tool in unforeseen circumstances.

Before any repair and maintenance work or 
transport, remove the device from the com-
pressed air source.

RISK OF INJURY! 

Do not use the device on 

scaffolds or ladders.

   Never use hydrogen, oxygen, carbon dioxide 

or other bottled gasses to power this tool as 
doing so may result in an explosion and thus 
may cause severe injuries.

RISK OF INJURY!

Do not use the device if 

the trigger lock 

9

 is damaged or has been 

removed. Otherwise injuries may result.

When loosening the hose coupling, hold the 
hose firmly in your hand to prevent injuries 
caused by a rebounding hose.

 Be absolutely certain to use a ¼

"

 threaded 

nipple and a quick-release coupling for the 
compressed air connection.

Never place your hands near the mouth when 
the device is ready to operate. Otherwise inju-
ries may result.

Pay attention to damage.

Check the de-

vice for damage before bringing it into use. If 
the device exhibits defects, it must not be oper-
ated under any circumstances.

Do not use any pointed objects. 

Never 

insert pointed and / or metal objects into the 
inside of the device.

Original  accessories / tools

Use only the accessories and attachments 
detailed in the operating instructions.

The use of fasteners or other accessories other 
than those recommended in the operating in-
structions could lead to you suffering an injury.

Preparing the product for use

NOTE:

 always wear the protective goggles sup-

plied before putting the tool into operation. Remove 
the protective film from the protective goggles before 
using for the first time.

Connecting the compressed  

air source

NOTE:

 The compressed air tacker must only be 

operated with cleaned, oil-misted compressed air 
and must not exceed the maximum operating pres-
sure of 8 bar. The compressor must be fitted with a 
pressure reducer in order to regulate the operating 
pressure.