Parkside KH 3052 SABRE SAW, Manual

11 

GB/IE/CY

Advice about ways of 
working when sawing

   Before sawing, check the workpiece for foreign 

bodies such as nails, screws etc. and remove 
them.

   Do not allow the ventilation slots to become 

covered.

   Switch the device on first and only then bring it 

into contact with the workpiece.

   If the saw blade jams, switch off the device im-

mediately. 

 Open the sawn gap in the workpiece slightly 
using a suitable tool and extract the saw blade. 

   Always make sure the saw blade type and the 

blade oscillation speed are suitable for the 
workpiece material.

   There are different saw blades available in var-

ious lengths designed to ensure optimum perform-
ance of every sawing task with your sabre saw.

   Saw the material using a steady forward rate 

of progress.

Flush sawing:

Using flexible saw blades of adequate length you 
can trim off projecting workpieces, such as pipes, 
directly at the face of a wall.

Follow these steps:
1.  Place the saw blade directly on the wall surface.
2.   Bend the blade by applying sideways pressure 

so that the shoe 

5

 comes up against the wall.

3.   Switch on the device as described above and 

trim the workpiece using constant pressure.

Plunge sawing:

CAUTION! DANGER OF KICKBACK!

Plunge sawing can be used only in soft materials 
(such as wood etc.).

Follow these steps:
1.   Place the sabre saw with the underside of the 

shoe 

5

 against the workpiece. 

Switch on the device.

2.   Tilt the sabre saw forward and plunge the saw 

blade into the workpiece.

3.   Bring the sabre saw vertical and continue saw-

ing along the cutting line.

Note:

 The saw blade used for this should not be 

longer than 150 mm!

Maintenance and cleaning

   Pull the mains lead out of the mains socket 

before you clean the device.

   Replace the saw blade as soon as its teeth be-

come blunt and it starts to produce defective 
saw cuts.

   Always keep the device and the ventilation 

slots clean. 

   Clean the device after you have finished using it.

   Do not allow any liquids to enter the device. 

Use a cloth to clean the housing. Never use 
petrol, solvents or cleaning agents that might 
attack plastic.

   If necessary, clean out the 

saw blade mounting recess 

with a thin paintbrush or compressed air. 

Service centre

WARNING!

Have your device 

repaired only by qualified specialist 
personnel using original manufacturer 
parts only.

 This will ensure that your device 

remains safe to use.

WARNING!

If the plug or mains 

lead needs to be replaced, always 
have the replacement carried out by 
the manufacturer or its service centre.

This will ensure that your device remains safe 
to use.

 Warranty

The warranty for this appliance is for 3 
years from the date of purchase. The ap-
pliance has been manufactured with care 
and meticulously examined before deliv-
ery. Please retain your receipt as proof 

Preparing  for  use / Maintenance  and  cleaning / Service  centre / Warranty