Parkside KH 3052 SABRE SAW, Manual

10 GB/IE/CY

chipboard, processed wood boards, plywood. 
Also suitable for plunge cuts.

Bi-metal saw blade 

12

:

Dimensions: 156 mm, 18 TPI
Most suitable for: Sawing sheets, profiles and tubes 
– flexible and fracture resistant.

Before use

Mounting / replacing 
saw blades

WARNING!

 Pull the mains plug out of the 

mains socket before you carry out any task on the 
device. Failure to observe this advice may lead to 
injury.

   Turn the quick-release chuck 

7

 and hold it in 

the turned position.

   Press the selected saw blade up to the stop 

into the quick-release chuck 

7

. The saw blade 

should engage.

   Release the quick-release chuck 

7

. The chuck 

must then return to its original position. The saw 
blade is now locked in place.

Rotating the hand grip

WARNING!

DANGER OF INJURY!

 Pull 

the mains plug out of the socket before you carry 
out any task on the device, The hand grip 

4

 can 

be rotated by 90° to the right or left. This allows 
the  ON / OFF  switch 

3

 to be brought into the most 

comfortable position for any working conditions.

   Press the unlocking button 

10

 and rotate the 

hand grip 

4

 to the right or left.

   Make sure the hand grip 

4

 engages.

Adjusting the shoe

WARNING!

 DANGER OF INJURY! 

Pull 

the mains plug out of the socket before you carry 
out any task on the device,

   Adjust the shoe 

5

 to suit the cutting depth.

   To do this release the shoe adjustment lever 

8

and place the shoe 

5

 in appropriate position.

   Lock the shoe in this position by pulling the 

shoe adjustment lever 

8

 tight.

Setting the blade speed

The desired blade oscillation speed can be prese-
lected by using the setting wheel 

1

 (MIN. = lowest 

oscillation speed, MAX. = highest oscillation speed). 
The blade speed can also be selected whilst you 
are using the device. 

Preparing for use

Switching on and off

When operating the device you can select between 
intermittent or continuous operation mode. 

To switch on intermittent operation mode: 

  Press the ON / OFF switch 

3

.

To switch off intermittent operation mode:

  Release the ON / OFF switch 

3

.

To switch on continuous operation mode:

   Press the ON / OFF switch 

3

 and fix it in the 

pressed position with the lock button 

2

.

To switch off continuous operation mode:

   Press the ON / OFF switch 

3

 and release it 

again.

Guiding the sabre saw 
safely and accurately

The shoe 

5

 pivots to adjust to the workpiece and 

provides safe support to the device. It must always 
lie against the workpiece when the device is in use.

General safety advice for electrical power tools / Before use / Preparing for use