PAEXS 20-Li A1
GB
│
IE
│
9
■
Dust box
Connecting
♦
Slide the dust box onto the appliance as far
as the stop.
Removal
♦
Pull the dust box off the appliance.
NOTE
►
To achieve optimum dust extraction, the dust
box should be emptied regularly.
♦
To do this, remove the dust box from the
appliance as described above. Open the dust
box by pulling on the tab and then removing
the lid. Clean both parts thoroughly by tapping.
Reducer
Connecting
♦
Push the reducer for external extraction appli-
ances into the adapter fitting .
♦
Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the reducer for external extraction appli-
ances
.
Removal
♦
Pull the hose of the vacuum cleaner off the
reducer for external extraction appliances
.
♦
Remove the reducer .
Use
NOTE
►
Always switch on the appliance before contact
with the material and then apply the tool to the
workpiece.
Adjusting the additional handle
You can adjust the additional handle to several
different positions.
♦
To reposition the additional handle undo
the screw .
♦
Move the additional handle to the required
position.
♦
Retighten the screw .
Switching on and off
Switching the appliance on
♦
Move the ON/OFF switch to the "I" position.
Switching the appliance off
♦
Move the ON/OFF switch to the "0" position.
Setting the rotational speed
♦
Adjust the speed setting wheel to a position
between 1 and 6.
Working procedures
■
Switch the appliance on before applying it to
the workpiece.
■
Apply minimal pressure when working.
■
Work at a constant speed.
■
Change the sanding sheets regularly.
■
Never use the same sanding sheet for sanding
different materials (e.g. wood followed by
metal). Optimum sanding results can only be
achieved by using clean sanding sheets.
Summary of Contents for PAEXS 20-Li A1
Page 3: ...A ...
Page 132: ...PAEXS 20 Li A1 128 DK ...